The pressure in an overfilled tank may cause leakage and lead to fuel spray and fire. Never let a passenger hold a child on his or her lap while the vehicle is moving. Let the transmission drain completely. The jack is only meant for changing the tire. Connecting the jumper cables 1. Use 1 First gear and set the parking brake fully. You can check the fluid without driving if the ambient temperature is above 10°C 50°F.
Make sure that the seat is relatched into place. Before adding transmission fluid, make sure that your engine was running when you checked the fluid level. Trailer towing tables F-150 4x2 with automatic transmission Engine. The relearning process will automatically complete as you drive the vehicle. Let the engine idle for at least one minute. Distributes outside air through the floor ducts. Vehicle uses a lot of gas, idles rough and experiences small hesitation upon acceleration.
Speaker fade adjust Speaker sound can be adjusted between the front and rear speakers. Ford recommends that all safety belt assemblies used in vehicles involved in a collision be replaced. After air bag deployment, it is normal to notice a smoke-like, powdery residue or smell the burnt propellant. If the gauge indicates low pressure, stop the vehicle as soon as safely possible and switch off the engine immediately. Do not pile cargo higher than the seatbacks to avoid injuring people in a collision or sudden stop. If you replace the fuel filter, replace it with an authorized Motorcraft part.
As the belt retracts, you will hear a clicking sound. If you need guidance, or step by step instructions, check out our , or get the , or our. Airflow will be from the instrument panel registers. Remove screw from the lamp assembly. If service is necessary, see your dealer or a qualified technician.
The high pressure fluid could penetrate the sealed parts and cause damage. If you use a rental trailer, follow the instructions that the rental agency gives to you. Illumination of the charging system warning light, Check Engine indicator light or the temperature warning light, fluid leaks, strange odors, smoke or loss of oil pressure, could indicate that the emission control system is not working properly. I am not sure of the torque value but the transmission is made ofT-6 and it would not be hard to strip the bolts so do not over tighten. Using the manual lumbar support Turn the lumbar support control toward the front of vehicle to increase firmness. Fill to bottom of filler hole.
F-150s and Super Duty trucks. For longer, trouble-free operation, keep the top of the battery clean and dry. You must complete steps 1-7 within 30 seconds or the procedure will have to be repeated. Refer to the Driving chapter for more information. We have compiled the handy chart below to help you select the correct Transfer Case Fluid for your Ford 4x4.
The customer warranty may be void for any damage to the fuel tank or fuel system if a genuine Ford or Motorcraft fuel filler cap is not used. Transmission operates in gears one through four. I will be consulting an attorney about persueing a lemon law claim. Refer to the scheduled maintenance guide for scheduled maintenance. Step 2 — Drain transmission Place the drain pan under the drain plug, then use the same socket to remove it. If you are experiencing erratic shifting, transmission. Rear axle lubricant quantities are not to be checked or changed unless a leak is suspected or repair is required.
Washing your vehicle Wash your vehicle regularly with cold or lukewarm water. Start the engine and let it run until it reaches normal operating temperature the engine coolant temperature gauge indicator will be near the center of the normal area between H and C. Make sure the headlamps and vehicle accessories are off. Ford transmission fluid supersession Information is current as July 2017. Ensure that the seat is relatched into place.